company news about Our D1.5 L22m 8 ply ship launching airbags 20 pcs used in UAE UAQ port

Our D1.5 L22m 8 ply ship launching airbags 20 pcs used in UAE port

Florescence ship rubber airbag comply with ISO 14409. ship airbag can be used to launch and upgrade a ship up to 100,000DWT. Comparing to the traditional slipway launching method, the ship launching airbags are much environmental, because ship airbag can launch a ship at any seaside, so there's no need to worry about the construction of launching facilities; besides, the marine airbag need little maintenance and can be used repeatedly.

Safety precaution

● Over pressure Control:

Strictly control the operating pressure, over pressure is forbidden.

● The Landing Slipway Requirements:

The landing ground should be ground or cement concrete, according the tonnage of different ships.

● Avoid Sharp Objects:

Make sure no sharp objects and make sure the smooth and clean ground during using them in case of break of airbag.

● Avoid Distortion And Overweight

Avoid distortion in the length direction during rolling and avoid overweight load after gas charging.

Storage

● When the airbags are not to be used for a long time, they should be drained, cleaned, dried, filled with talc power, and the exterior surfaces should be coated with talc power.

● The airbags should be maintained in a dry ventilated room and be protected from light.

● The airbags should be in a relaxed condition free from tension, compression or other deformation.

● The airbags should be kept away from any heat source.

● The airbags should be protected from acids, alkalis, oils or organic solvents.